***IMPORTANT***
Before you can start using the LED Magician, please select the correct input voltage by shorting the connections labelled "8-28V" or "4.5V".
If you are using an input voltage that is between 4.5Volts to 8Volts, solder the connection labelled "4.5V" (Fig. 1)
If you are using an input voltage that is 8Volts and above, solder the connection labelled "8-28V" (Fig. 2)
Fig. 1 Fig. 2
LED Magician Installation instructions
- Connect power supply’s negative (-) to terminal labelled “V0”
- Connect power supply’s positive (+) to terminal labelled “V+”
- Connect LED(s) anode (+) to output terminals labbelled “V+”
- Connect LED(s) cathode (-) to output terminals labbelled “1” to “12”
- Control sequences via onboard control buttons.
LED Magician Connection Diagrams
You can connect the positive (+) and negative (-) of your LED(s) from each channel output. (example 1)
Example 1.
Or you can connect the negative (-) of your LED(s) to the channel output and share the positive output on your LEDs, please see example 2 below. Both methods work the same.
Example 2.
On Board Buttons
Use button 1 & 2 to select blinking sequences. Up to 32 sequences are selectable. Press and hold for 2 seconds to reset to default sequence
(Default sequence cycles through all 32 sequences)
Use button 3 & 4 to select speed. Up to 8 speeds are selectable. Press and hold for 2 seconds to reset to default speed.
List of Blinking/Fading Sequences (32 modes)
- LOOP ALL MODES
- COMET
- COMET BACK AND FORTH
- TRAIN
- TRAIN BACK AND FORTH
- BOUNCE
- COLLISION
- SEPARATION
- CENTER BUILD UP FROM LEFT AND RIGHT
- CENTER BUILD UP FROM LEFT AND RIGHT (RANDOM OFF)
- DOOR CLOSING
- SPRING
- CRISS-CROSS (RANDOM OFF)
- CRISS-CROSS (SLOW OFF)
- CENTER BUILD UP FROM LEFT, THEN RIGHT
- CENTER BUILD UP FROM LEFT, THEN RIGHT (RANDOM OFF)
- PENDULUM
- 1 DOT WATER FLOW
- 1 DOT WATCH FLOW BACK AND FORTH
- 2 DOTS WATER FLOW
- 2 DOTS WATER FLOW BACK AND FORTH
- 3 DOTS WATER FLOW
- 3 DOTS WATER FLOW BACK AND FORTH
- 4 DOTS WATER FLOW
- 4 DOTS WATER FLOW BACK AND FORTH
- FADE IN, FADE OUT
- FLASHING (STROBE)
- FLASHING (STROBE) LEFT AND RIGHT
- FLASHING (STROBE) POLICE LIGHT
- ALTERNATE FADE IN AND OUT
- RANDOM ON, RANDOM OFF
- DISCO LIGHTS
Installing external controls
You can wire-out external controls by using the through-holes located at the top right corner of the circuit board.
Using a micro-controller;
A "push" of the control buttons are simulated via an "active low" TTL signal from your micro-controller.
The connection should be kept "high" at 5v and a "low" level signal simulates a press of the switch.
Have a question? Find your answers at our "Frequently Asked Questions" page